"This site uses cookies to provide and improve your shopping experience. By continuing to use this site, you agree to accept these cookies. For more information, please click here."
RAID Adapter for connecting two SATA Drives to a host computer
Supports SATA I (1.5Gbps) SATA II (3Gbps) SATA III (6Gbps), RAID 1, RAID 0, SPAN (Big Drive) and PM (2Drives) mode
Automatic "Rebuild" function, Native Command Queue (NCQ) and auto-negotiation
100% OS-transparent supports PC, Mac and Linux (driver not required for modern OS)
2 years warranty
The LINDY 6 Gbps Hardware RAID Adapter allows you to connect two SATA hard drives to a single host port. The drives can then be set up in a variety of RAID configurations via the adapter jumpers to appear individually or as a single drive.
Note: Changing the RAID mode will lead to a reconfiguration of the disk array, erasing all data on the hard drives. Where possible, it is advised you backup any critical data before performing this task.
Multilane, 4 external Serial-ATA-II connections for your PC! Supports data rates of up to 3 Gbit/sec., RAID5, JBOD, Port Multiplier and NCQ. This PCI-X (64 Bit PCI) host adapter can be used to expand a PC with four external SATA II interfaces via the Multilane connection. This card supports a 64bit, 133 MHz Interface on the host side and four autonomous SATA-II ports on the device side. The external connection is a multilane connection. The multiline connection can be used to send to up to four SATA II interfaces. Data is sent to the external connection with a multilane cable (Order No. 33225).
Converts M.2 (NGFF) PCIe SDD for use in PCIe x4 slots
Supports PCIe Gen3 and Gen2 M.2 NGFF 110mm, 80mm, 60mm, 42mm form factors
Compatible with NVMe and SATA based SSDs
M.2 NGFF type 22110-D5-M connector on board
2 Year Warranty
The LINDY M.2 SSD to PCIe Adapter Card allows high performance PCIe based SSDs to be installed in a typical PCIe x4 slot commonly found on desktop PCs and servers. Using NVMe technology that was built specifically for SSDs allows super fast connection speeds. Supporting dual sided SSD modules with 1.5mm component height and a wide range of lengths allows most modules to be installed with ease.
Please note: SATA Based SSD Modules are not compatible with this adapter card. To boot from NVMe SSDs you will need appropriate BIOS support.