For destinations within the European Union (EU), delivery will usually be made within two to five working days of despatch, depending on service and country.
Orders received and accepted before 3.00pm (CET) will be despatched on the same working day, subject to availability.
We offer fixed rate delivery costs to most mainland EU countries. The delivery costs to each country are shown in the table below.
If the country you require is not in the list or if you are a Business (Trade) account holder, please contact us, and we will calculate the delivery cost for you.
This product has been discontinued and replaced by Part No 36241.
VI-D Single Link Male to DVI-D Single Link Male
For use with all modern digital monitors, projectors and TFT/LCD Flat Panel Displays
UXGA (1600 x 1200) and HDTV1080i (1920 x 1080) compatible
RF-BLOK shielded design
10 Year Warranty
LINDY Super Long Distance DVI cables use a specially developed and optimised cable material that allows longer cable distances than the 7.5m maximum recommendation laid down by the DDWG (Digital Display Working Group).
Please note: Maximum supported distances and resolutions are dependent on both the monitor and the chipset used in the graphics card.
Features of the RF-BLOK shielded design:
Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
Increased insulation resistance up to 25%
No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
Tight fit of internal wires as there is no inner mould
No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
Smaller overall dimensions which allows more room behind the host or peripheral
Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one