Allow convenience functions
Allow shop optimisations
In order to optimise our website, we use services that collect and aggregate data and make it available to us as a statistical overview.
This temperature & humidity sensor for Lindy IPower Switch Pro 8 provides reliable information about the environment temperature and humidity. The small form factor and a 1.8m (5.91ft) long cable allows a flexible and discreet installation.
Consists of 1 x Injector cable and 1 x Splitter cable
Maximum voltage: 24V, Maximum current: 800mA
Male and Female DC power jacks (2.1mm) for connection to device and power supply
Ideal for use with existing installations where additional power cables cannot be installed easily
2 Year warranty
Please note: This passive POE adapter kit is intended for a point to point connection between the connected device and an active network connection. It must not be directly connected or routed through any network switches or routers. Operating distances may vary depending on the cable type used and the power requirements of the connected device.
Our Passive Power Over Ethernet Kit is a low cost solution designed for use with all network devices that operate with a supply voltage of up to 57 Volts DC. The simple adapter cables allow both power and data to be transmitted over a single network cable. It uses the unused data pairs to inject power over a single network cable. This kit is perfect for use with IP cameras, access points hubs and switches. Simply connect the power supply provided with your device to the injector cable and connect the splitter to your device.
The network time server acts as a stand-alone SNTP server.
All computers on its local network can synchronise its system time with the network at any time.
The time server itself is permanently synchronised via the long wave time signal sent by the DCF77 transmitter in Mainflingen, Germany. This signal is generated from one of the most precise atomic clocks in the world. It is controlled by the Physically-Technical Federal Institution in Brunswick, Germany and deviates by less than one second in 300,000 years. If the time signal reception is ever lost or in the event of a power cut, the time server will automatically take over the timing via an integrated battery-buffered Quartz clock, and automatically returns to DCF77 mode once the reception has been restored.
Your complete network will always have a highly accurate system time.
Remote management switch for up to 8 computers or other devices
Daily, Weekly, Monthly & Yearly Power Consumption Data
IPv4 and IPv6 Support
TLS/SSL Web Browser (Https) for set up and operation
2 year warranty
This IP Power Switch Classic 8 is an advanced power management solution which connects to your existing network infrastructure to provide convenient remote control power management and monitoring of equipment. System administrators can control the power to multiple servers, workstations, hubs, switches, routers etc allowing reboot and power-on and off functions, via a simple to use browser interface.
The Lindy IPower Switch 4 DIN S Pro allowes switching of 4 different relay outputs and monitoring of 8 passive signal inputs. It also supports a master command to switch off all relays at the same time.
For monitoring, it supports a web based configuration which is also able to send automaticly generated emails including all configured data.
Ideal for the use within medium size areas like AV Installations, to control the power supply of different devices from a control room or other locations, outside the installation area.
Cross-platform operation via web interface - HTTP(S) based, email (SSL, STARTTLS)
2 year warranty
The Lindy IPower Control Plus IEC Pro allows you to manage the power of a single device over an IP based network. It connects to your existing network to provide remote control power operation of a connected server, workstation, hub, router or almost any other mains - IEC C13 - powered device. A simple web interface allows rebooting and control of power on/off functions.
Note: For connecting your device to the IPower Switch you will need an IEC to IEC Extension Cable.