Consists of 1 x Injector cable and 1 x Splitter cable
Maximum voltage: 9-24V, Maximum current: 800mA
Male and Female DC power jacks (2.1mm) for connection to device and power supply
Ideal for use with existing installations where additional power cables cannot be installed easily
2 Year warranty
Please note: This passive POE adapter kit is intended for a point to point connection between the connected device and an active network connection. It must not be directly connected or routed through any network switches or routers. Operating distances may vary depending on the cable type used and the power requirements of the connected device.
Our Passive Power Over Ethernet Kit is a low cost solution designed for use with all network devices that operate with a supply voltage of up to 57 Volts DC. The simple adapter cables allow both power and data to be transmitted over a single network cable. It uses the unused data pairs to inject power over a single network cable. This kit is perfect for use with IP cameras, access points hubs and switches. Simply connect the power supply provided with your device to the injector cable and connect the splitter to your device.
Well-housed- the shelf range for LINDY 19" upright- and wall-mounted enclosures A wide range of fixed shelving floors with various load bearing capacities and depths are available for current LINDY wall-mounted enclosures, up-right cabinets and open rack panels.
When used in conjunction with our IPower Control 8 Port this sensor will measure the ambient temperature within a network enclosure. The current temperature can be viewed using a web browser interface in conjunction with IPower Control 8 Port.
MiniGbic slot (SFP) supporting either multimode or single mode fibre modules (100/1000Base-SX 25015 or LX 25029)
RJ45 for the 10/100 base TX and 1000BaseT connectivity
SFP Slot for 100Mbit or Gigabit MiniGbic Modules
Operating Temperature: -10~55ºC
Storage Temperature: -40~70ºC
Humidity 5% - 90% non-condensing, for indoor use only
Supplied with Multi-country PSU - Input: 100-240V AC 0.25A Output: 5V DC 1A (5.5/2.1mm DC Connector)
This device will allow you to interconnect a Fiber Network through a standard SFP (MiniGBIC) module to a Gigabit or 10/100Mbit copper network. The SFP slot can accept Multimode or Singlemode modules as well as Gigabit or 100BaseFX modules.
The fibre optic signal is totally immune to electromagnetic and radio frequency interference, and electrically isolated - ideal for high speed inter-connections up to 1000Mbps (Full-duplex) between buildings and floors.
Due to the high temperature resistance of -10 to + 55 ° C, this media converter is ideally suited for use in industrial environments.
Standard SFP+ module form factor (CISCO and HP compatible)
Duplex LC Connector
850nm wavelength (Multimode only)
2 Year Warranty
The LINDY Transceiver Module allows a 10 Gigabit fibre optic connection to your network. Simply connect this 10GBase-SR module to your 10G Ethernet switch with a multimode LC duplex cable for quick and easy connectivity.
Standard SFP+ Module for common networking systems like Cisco, HP, Dell, Ubiquiti, D-Link, Zyxel, Netgear, Arista, Juniper or for mainboards with SFP+ slots like SuperMicro, Asus, Gigabyte and Asrock.
The module is built to comply with MSA (Multi Sourcing Agreement) standards and uses the industry standard LC interface to extend your network connectivity up to 400m. It is also is fully hot pluggable, which enables you to install it without powering down your network switch and interrupting traffic flow.
Please note: This module is only compatible with 10G switches. 1G or 10/100 switches are not supported.