Consists of 1 x Injector cable and 1 x Splitter cable
Maximum voltage: 24V, Maximum current: 800mA
Male and Female DC power jacks (2.1mm) for connection to device and power supply
Ideal for use with existing installations where additional power cables cannot be installed easily
2 Year warranty
Please note: This passive POE adapter kit is intended for a point to point connection between the connected device and an active network connection. It must not be directly connected or routed through any network switches or routers. Operating distances may vary depending on the cable type used and the power requirements of the connected device.
Our Passive Power Over Ethernet Kit is a low cost solution designed for use with all network devices that operate with a supply voltage of up to 57 Volts DC. The simple adapter cables allow both power and data to be transmitted over a single network cable. It uses the unused data pairs to inject power over a single network cable. This kit is perfect for use with IP cameras, access points hubs and switches. Simply connect the power supply provided with your device to the injector cable and connect the splitter to your device.
Standard SFP+ module form factor (CISCO and HP compatible)
Duplex LC Connector
1310nm wavelength (Singlemode only)
2 Year Warranty
The LINDY Transceiver Module allows a 10 Gigabit fibre optic connection to your network. Simply connect this module to your 10G Ethernet switch with a singlemode LC duplex cable for quick and easy connectivity.
Standard SFP+ Module for common networking systems like Cisco, HP, Dell, Ubiquiti, D-Link, Zyxel, Netgear, Arista, Juniper or for mainboards with SFP+ slots like SuperMicro, Asus, Gigabyte and Asrock.
The module is built to comply with MSA (Multi Sourcing Agreement) standards and uses the industry standard LC interface to extend your network connectivity up to 10Km. It is also is fully hot pluggable, which enables you to install it without powering down your network switch and interrupting traffic flow.
Please note: This module is only compatible with 10G switches. 1G or 10/100 switches are not supported.
Cross-platform operation via web interface - HTTP(S) based, email (SSL, STARTTLS)
2 year warranty
The Lindy IPower Control Plus IEC Pro allows you to manage the power of a single device over an IP based network. It connects to your existing network to provide remote control power operation of a connected server, workstation, hub, router or almost any other mains - IEC C13 - powered device. A simple web interface allows rebooting and control of power on/off functions.
Note: For connecting your device to the IPower Switch you will need an IEC to IEC Extension Cable.