In order to optimise our website, we use services that collect and aggregate data and make it available to us as a statistical overview.
You are here: » Homepage
The LINDY Transceiver Module allows a 10 Gigabit fibre optic connection to your network. Simply connect this module to your 10G Ethernet switch or to an Extender with SFP+ slot with a singlemode LC duplex cable for quick and easy connectivity.
Standard SFP+ Module for common networking systems like Cisco, HP, Dell, Ubiquiti, D-Link, Zyxel, Netgear, Arista, Juniper or for mainboards with SFP+ slots like SuperMicro, Asus, Gigabyte and Asrock.
The module is built to comply with MSA (Multi Sourcing Agreement) standards and uses the industry standard LC interface to extend your network connectivity up to 10Km. It is also is fully hot pluggable, which enables you to install it without powering down your network switch and interrupting traffic flow.
Please note: This module is only compatible with 10G switches. 1G or Fast Ethernet switches are not supported.
This Lindy Media Converter extends the connection between two network devices at distances up to 550m using multimode fibre optic cables. The installation is plug-and-play and the user only has to connect to the RJ45 port with a Cat.5e or above Ethernet cable and the fibre port with a SC Multimode 50/125 or 62.5/125 Duplex fibre optic cable. No configuration needed, easily integrated into any existing Ethernet network and supports Full/Half duplex mode and auto-negotiation on both ports.
The Media Converter can operate with 100 or 1000Mbps network speed, it also provides status LEDs to indicate data link, speed, Full/Half Duplex and link failure. Supports IEEE 802.3 standard and Jumbo frames up to 9K.