For destinations within the European Union (EU), delivery will usually be made within two to five working days of despatch, depending on service and country.
Orders received and accepted before 3.00pm (CET) will be despatched on the same working day, subject to availability.
We offer fixed rate delivery costs to most mainland EU countries. The delivery costs to each country are shown in the table below.
If the country you require is not in the list or if you are a Business (Trade) account holder, please contact us, and we will calculate the delivery cost for you.
For use with all modern digital monitors, projectors, and TFT/LCD Flat Panel Displays
Dual Link digital connection supports display resolutions of up to 2560 x 1600
RF-BLOK shielding design
Connectors: DVI-D Dual Link Male to DVI-D Dual Link Female
10 Year Warranty
Features of the RF-BLOK shielded design:
Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
Increased insulation resistance up to 25%
No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
Tight fit of internal wires as there is no inner mould
No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
Smaller overall dimensions which allows more room behind the host or peripheral
Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one
Please note that cable lengths over 7.5m are above the recommended length laid down by the DDWG organisation who developed the specification. This factor also depends on the hardware combination of graphics card and monitor as to how far this distance can be exceeded.