For destinations within the European Union (EU), delivery will usually be made within two to five working days of despatch, depending on service and country.
Orders received and accepted before 3.00pm (CET) will be despatched on the same working day, subject to availability.
We offer fixed rate delivery costs to most mainland EU countries. The delivery costs to each country are shown in the table below.
If the country you require is not in the list or if you are a Business (Trade) account holder, please contact us, and we will calculate the delivery cost for you.
Ideal for digital signals, audio and video presentations.
These extenders support data transmission in the following modes: "1 to 1", "1 to many", and "many to many".
HDMI Full HD 1080p and HDCP compatible
The transmitter and receiver can be connected via a dedicated Cat.5e/6 RJ45 cable up to 120m in length or via an Ethernet network with up to three layers
Simply connect to power, connect the transmitter to the signal source with the HDMI cable, and connect the receiver to the monitor or projector.
For information about network requirements, see Technical details
This extender transmits compressed signals in Full HD 1080p resolution. For motion video the compression is almost invisible. For presentations and static desktops a loss of sharpness similar as known from JPEG photo compression can be recognized.
The HDMI distribution solution offering the best value for money
The extender sends HDMI signals with HDCP and Audio digitally in full 1080p resolution. It has a lightweight, scarcely noticeable form
The transmitter and receiver can either be connected 1:1 via a Cat.5e/6 RJ45 cable up to 120m in length or via an Ethernet network with up to three layers
1:n and n:n connections require Ethernet. Always use one separate network or a segment separated by a VLAN connection per transmitter.
Supports HDTV resolutions up to Full HD 1080p and 8 Bit colour depth, with HDCP
3D is not supported
Transmitter with HDMI input
Receiver with HDMI output
Transmitter and Receiver each with RJ45 sockets and 100BaseT interface
The network components and switches in use must support the broadcast protocol, otherwise the attempt to connect may fail and fault-free operation cannot be guaranteed. Note: some older configurable switches have not implemented the broadcast protocol correctly. In such cases, the attempt to connect will fail
WIFI routers in home networks do NOT normally offer suitable protocol support!
IR remote control support
Also supports IR remote control signals (38kHz***, range 940 nm)
IR receiver cable for connection to receiver
IR transmitter cable for connection to transmitter
Power and status LEDs
Dimensions approx. 9.5 x 10.5 x 2.5 cm of transmitter or receiver respectively
Weight approx. 0.3kg for transmitter or receiver respectively, total weight approx. 0.5 kg incl. packaging
Included in the delivery
Transmitter (No.38127) or receiver (No.38128)
IR remote control TX/RX cable
Universal power supply 100...240VAC / 5VDC ~1A, with adapters for Euro-, US-, UK- and Australian power outlets
*** Many of the various Sky receivers use IR remote controls in the 20kHz range - these are not supported
***This extender transmits compressed signals in Full HD 1080p resolution. For motion video the compression is almost invisible. For presentations and static desktops a loss of sharpness similar as known from JPEG photo compression can be recognized.
Write a review