For destinations within the European Union (EU), delivery will usually be made within two to five working days of despatch, depending on service and country.
Orders received and accepted before 3.00pm (CET) will be despatched on the same working day, subject to availability.
We offer fixed rate delivery costs to most mainland EU countries. The delivery costs to each country are shown in the table below.
If the country you require is not in the list or if you are a Business (Trade) account holder, please contact us, and we will calculate the delivery cost for you.
Converter for 2.5" hard drives and SSDs with 22/29-pole SATA Backplane connection
Fits into every standard 3,5" slot with screw fixing on the underside
Also fits into any 3.5" SATA Backplane - has identical dimensions and connections as a 3.5" SATA HDD
Supports SATA hard drives and SSDs with installation heights of up to 15mm
Converter with latching lever and automatic ejection mechanism
Simply install this adapter frame and converter into the 3.5" slot on your desktop or you can use it like a 3.5" drive in a 3.5" converter!
2.5" drives only need a fraction of the energy needed by a 3.5" drive and a voltage supply of just 5V instead of 5V and 12V. They generate considerably less heat and are considerably quieter when running.
As this adapter frame has the same dimensions and SATA connections as a 3.5" SATA hard drive, it can be used just like a 3,5" SATA drive - this solution uses considerably less energy and produces less heat and noise.
Many PC enclosures allow you to attach 3.5" format hard drives and converters on the underside. This is also possible for this converter.
With converter housings where only side screw attachment is possible, this converter does not have the screw attachment at the same positions as a 3.5" drive: the 3 threaded holes on the side have a clearance from the bottom of 6mm instead of 5mm, only the hole at the extreme rear has the same clearance from the front edge (115 mm); the two front holes however have a clearance of 25 and 85 mm from the front edge.
If 1mm of space is available above the slot, this allows the converter to usually only be attached with the threaded holes at the rear.
Where this is not possible, you can use the LINDY converter No.20969 (max. drive height of 7.5 mm) with standard side attachment instead
Multipurpose converter for 2.5" SATA hard drives and SSDs!
External interface 22-pole SATA connection- as a 3.5" SATA HDD
Hot-swap support- when supported by the operating system, drives can also be swapped while running
2.5" drive/SSD slots directly into the converter- no carrier or tool needed
Converter with latching lever in front door
Automatic ejection mechanism for the drive - also works even if the PC is switched off
Fan-less - with vent slots thanks to ventilation concept of housing