Standard SFP+ module form factor (CISCO and HP compatible)
Duplex LC Connector
850nm wavelength (Multimode only)
2 Year Warranty
The LINDY Transceiver Module allows a 10 Gigabit fibre optic connection to your network. Simply connect this 10GBase-SR module to your 10G Ethernet switch with a multimode LC duplex cable for quick and easy connectivity.
Standard SFP+ Module for common networking systems like Cisco, HP, Dell, Ubiquiti, D-Link, Zyxel, Netgear, Arista, Juniper or for mainboards with SFP+ slots like SuperMicro, Asus, Gigabyte and Asrock.
The module is built to comply with MSA (Multi Sourcing Agreement) standards and uses the industry standard LC interface to extend your network connectivity up to 400m. It is also is fully hot pluggable, which enables you to install it without powering down your network switch and interrupting traffic flow.
Please note: This module is only compatible with 10G switches. 1G or 10/100 switches are not supported.
Individually control up to 4 power sockets via LAN or WAN
Can be controlled using the LINDY app or web browser
Supports DHCP or manual IP address allocation
Password protected access
2 year warranty
The LINDY IPower Strip 4 is a power management solution which connects to your existing network infrastructure to provide convenient remote control power management of equipment. System administrators can now control the power to multiple servers, workstations, hubs, switches, routers etc. allowing reboot and power-on and off functions, via a simple to use browser interface.
Quickly test network cables for wiring continuity, open, shorts and mis-wires
Separate Remote Tester for pre-installed cables
Status LED for each individual wire
Complete with Soft Carry Case
2 year warranty
The LINDY Network Cable Tester is a compact, palm sized unit for testing network cables.
It can be used to read and check the pin-out configuration before and after installation.
A separate passive module is included for remote testing of pre-installed cables. A single switch starts the automatic cable test, indicating the pin-to-pin configuration and quickly highlights any underlying problems by using the LED display.
It also features an "S" mode that allows the pinout information readout to be slower.